Source code for spinnman.messages.scp.enums.scp_command

# Copyright (c) 2014 The University of Manchester
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#     https://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.

from enum import Enum


[docs] class SCPCommand(Enum): """ The SCP Commands. """ # ======== SARK ======== #: Get software version. CMD_VER = 0 CMD_RUN = 1 #: Read SDRAM. CMD_READ = 2 #: Write SDRAM. CMD_WRITE = 3 CMD_APLX = 4 CMD_FILL = 5 # ======== SCAMP ======== CMD_COUNT = 15 CMD_REMAP = 16 #: Read neighbouring chip's memory. CMD_LINK_READ = 17 #: Write neighbouring chip's memory. CMD_LINK_WRITE = 18 CMD_AR = 19 #: Send a Nearest-Neighbour packet. CMD_NNP = 20 #: Copy a binary from an adjacent chip and start it CMD_APP_COPY_RUN = 21 #: Send a Signal. CMD_SIG = 22 #: Send Flood-Fill Data. CMD_FFD = 23 CMD_AS = 24 #: Control the LEDs. CMD_LED = 25 #: Set an IPTAG. CMD_IPTAG = 26 CMD_SROM = 27 #: Allocate or Free SDRAM or Routing entries. CMD_ALLOC = 28 #: Initialise the router. CMD_RTR = 29 #: Dropped Packet Reinjection setup. CMD_DPRI = 30 #: Get Chip Summary Information. CMD_INFO = 31 #: Control sending of synchronisation messages. CMD_SYNC = 32 # ======== BMP ======== #: Get BMP info structures CMD_BMP_INFO = 48 CMD_FLASH_COPY = 49 CMD_FLASH_ERASE = 50 CMD_FLASH_WRITE = 51 CMD_RESET = 55 #: Turns on or off the machine via BMP. CMD_BMP_POWER = 57 # ======== OUTBOUND (OBSOLETE) ======== CMD_TUBE = 64